
How Often Should a Commercial Building Get an Electrical Safety Inspection?
November 3, 2026
How Often Should a Commercial Building Get an Electrical Safety Inspection?
November 3, 2026
Does a Custom Home Need Whole-Home Surge Protection?

For most new custom homes, the answer is yes. Whole-home surge protection installed at the panel guards the wiring, appliances and smart systems a modern home depends on.
Homeowners and builders work with our residential electricians in Berkley, MI to add it during construction, remodels and upgrades.
Here's what you need to know about protecting a custom home from power surges.
What a Power Surge Does to a Home
A surge is a brief spike in voltage that travels through the wiring. Storms, utility switching and large appliances cycling on and off can all cause one.
A single large spike can ruin equipment in an instant. Smaller, repeated spikes wear down circuit boards over time, so electronics fail years earlier than they should.
Why Custom Homes Have More at Stake

Custom homes tend to carry far more electronics than a standard house. Smart lighting controls, security cameras, home theaters, wine room cooling and high-end kitchen appliances all run on sensitive circuit boards.
That equipment is part of the reason surge protection belongs on the list when you plan a luxury home's electrical system. Replacing one smart appliance can cost more than the protection itself.
How a Whole-Home Surge Protector Works
A whole-home surge protector mounts at or next to the main electrical panel. When voltage spikes, it sends the excess energy to ground before it spreads through the home's circuits.
Because it sits at the service, it covers hardwired equipment that a plug-in strip never reaches. Think furnaces, air conditioners, ovens, lighting controls and built-in audio systems.
What the Electrical Code Says
Surge protection is no longer only an upgrade. The 2020 edition of the National Electrical Code added Section 230.67, which calls for a Type 1 or Type 2 on services that supply dwelling units.
Which code edition applies depends on what your local jurisdiction has adopted. A licensed electrician can confirm the requirement for your project and permit.
Lightning Losses Are Real
Lightning is not the most common cause of surges, but it is the most expensive. Insurers paid about 62,000 in 2025, averaging $26,616 per claim, according to the Insurance Information Institute.
No device can promise protection from a direct strike. A panel surge protector does lower the risk from the nearby strikes and utility spikes that reach a home through its service lines.
The Best Time to Add It
The easiest time to add surge protection is during new construction, when the panel and circuits are going in. It fits naturally alongside the other questions in our new construction wiring guide.
Existing homes can add it too, often during electrical panel and service upgrades. If you also have a breaker that keeps tripping, have both looked at in the same visit.
Frequently Asked Questions
Do I still need plug-in surge protectors with a whole-home system?
Plug-in protectors are still a smart second layer for computers, TVs and other sensitive electronics. The panel device handles surges entering through the service, while a point-of-use strip adds protection right at the outlet.
Bob Vila's guide also suggests an uninterruptible power supply with built-in surge protection for equipment that cannot lose power suddenly.
How long does a surge protector last?
Surge protectors do wear out, because each surge they absorb uses up part of their capacity. Bob Vila's guide says many surge protectors last about three to five years, and frequent surges can shorten that.
Watch for an indicator light that is off or flickering, burn marks or buzzing. Any of those signs means the device should be checked or replaced.
Should surge protection be checked after a storm?
Yes, a quick check after a severe storm is a good habit once the power is back on. Look at the indicator lights on the panel unit and on plug-in strips, and note any electronics acting strangely.
If a light is out or you are not sure the device still works, an electrician can inspect it and confirm whether it can still handle surges.
Can J. Simon & Sons add surge protection to an existing home?
Yes. J. Simon & Sons primarily supports custom homes during new construction, but the team also provides surge protection for luxury home remodels, renovations and electrical upgrades throughout Metro Detroit.
Replacing a panel is a natural time to add it. Under the 2020 National Electrical Code, surge protection must be installed when service equipment is replaced.
What does J. Simon & Sons' surge protection service cover?
The service covers whole-home surge protector installation, electrical panel surge protection and dedicated circuit protection. It also includes protection for smart home systems, appliances, home offices and entertainment systems.
The same team handles panel upgrades, troubleshooting and electrical safety inspections. Reach J. Simon & Sons Electrical Contractors at (248) 399-4640 with questions about your home.
Protect Your Custom Home With J. Simon & Sons
A surge protector is a small part of a custom home's electrical system, but it protects nearly everything else. Our team has served Metro Detroit for more than 100 years and can fit whole-home surge protection into a new build or remodel.
Trust our Berkley, MI custom home electricians for custom luxury home electrical services built to last. Call J. Simon & Sons Electrical Contractors today at (248) 399-4640 to plan your surge protection, or request a quote online.
